How to wrap wiring

If none of the above categories fit your question or comment, post it here!

Moderators: a j r, TDockside, Miles, Moderators

How to wrap wiring

Postby JALL » Sun Nov 04, 2012 11:21 am

What is the best way to wrap the wiring from the dash to the motor? I was thinking about using heat shrink tubing but I believe wire loom is cheaper. Thanks for any ideas.
Posts: 113
Joined: Tue Aug 24, 2010 4:39 am

Postby Phill Blank » Sun Nov 04, 2012 11:36 am


I have used the spiral split wire loom material for all my wiring runs. It is easy to add additial wire as needed or to bring out a set of wires any place along the wire run for accessories. I use tape to hold wiring in place at ends and any that break out along the run. I also use the plastic wire loom clips with screws to anchor to the ribs or cross members under the decking.

Good Luck,

Phill Blank
Posts: 412
Joined: Thu Jan 05, 2006 4:20 pm
Location: Hurley, Wisconsin

Return to Miscellaneous

Who is online

Users browsing this forum: No registered users and 6 guests