Page 1 of 1

How to wrap wiring

Posted: Sun Nov 04, 2012 11:21 am
by JALL
What is the best way to wrap the wiring from the dash to the motor? I was thinking about using heat shrink tubing but I believe wire loom is cheaper. Thanks for any ideas.

Posted: Sun Nov 04, 2012 11:36 am
by Phill Blank
JALL,

I have used the spiral split wire loom material for all my wiring runs. It is easy to add additial wire as needed or to bring out a set of wires any place along the wire run for accessories. I use tape to hold wiring in place at ends and any that break out along the run. I also use the plastic wire loom clips with screws to anchor to the ribs or cross members under the decking.

Good Luck,

Phill