Finishing the outside

Questions/concerns/issues. How did the other guy do it? Find out here.

Moderators: TDockside, Miles, a j r, Moderators

Finishing the outside

Postby gaff » Fri Jul 27, 2012 4:30 am

Well it has been slow going but I am about done with the interior of the boat. I have refinished the seats, seat supports and dashboards and have 6 coats of varnish on the inside after about 90% of the ribs were replaced, replaced the transom and the stringers. 2 more coats of varnish to follow.

https://app.photorocket.com/galleries/e ... 5a2e9beb14


I am going to start the finishing process on the outside of the hull.

I am planning to use System 3 epoxy fairing putty to fill screw holes, divots and smooth things out before I install the spray rails.

I treated the inside with CPES. Should that be done on the outside as well or go straight to the fairing putty?

Thanks

Steve
gaff
 
Posts: 86
Joined: Sun May 15, 2011 2:58 pm
Location: Georgia

Postby Phill Blank » Fri Jul 27, 2012 6:26 am

GAFF,

I would sugest the CPES before the putty.

Good Luck,

Phill
Image
Phill Blank
 
Posts: 412
Joined: Thu Jan 05, 2006 4:20 pm
Location: Hurley, Wisconsin


Return to Restoration

Who is online

Users browsing this forum: No registered users and 9 guests

cron