Questions/concerns/issues. How did the other guy do it? Find out here.
Moderators: TDockside, Miles, a j r, Moderators
by JALL » Thu Dec 15, 2016 7:24 am
I'm not sure what it is called but can you cut off the bad part of the rib square and replace with good wood and then use another piece of rib over the top of the repair and long enough to over-lap the joint? Thanks for any help
-
JALL
-
- Posts: 113
- Joined: Tue Aug 24, 2010 4:39 am
- Location: WISCONSIN
by LancerBoy » Thu Dec 15, 2016 9:29 am
That's not the best approach but I have seen it done on boats. The best way is to use a sloped scarf cut in the end of the ribs. Glue and screw or bolt the scarf together.
Andreas
-
LancerBoy
-
- Posts: 1417
- Joined: Mon Jan 28, 2008 3:47 am
- Location: Minneapolis
by JALL » Thu Dec 15, 2016 9:40 am
The fellow that I was talking to said it was just as strong. Do you agree?
-
JALL
-
- Posts: 113
- Joined: Tue Aug 24, 2010 4:39 am
- Location: WISCONSIN
by steve in texas » Thu Dec 15, 2016 8:01 pm
No, i am with Andreas. I used angled scarf with screws and west system; tested it and has held so far.
-
steve in texas
-
- Posts: 67
- Joined: Wed Aug 05, 2015 10:48 am
by thegammas » Fri Dec 16, 2016 4:12 am
Scarf joint for sure.
Peter Stransky
1962 Cortland Custom Sea Lancer
Wilmington, Delaware
-
thegammas
-
- Posts: 563
- Joined: Sat Nov 25, 2006 2:10 pm
- Location: Wilmington, Delaware. peterstransky@verizon.net - put wooden boat in the subject
Return to Restoration
Who is online
Users browsing this forum: No registered users and 5 guests